Msd Tach Adapter Wiring

Splice the red wire from the pn 8910 into the msd s red switched 12 volts wire.

Msd tach adapter wiring. Once the wire has been located it is recommended to check for 12 volts using a volt meter. Run enough wire to reach the msd ignition control box mounted on the firewall in the engine compartment. Mount the tach adapter in a location away from direct engine heat making sure the wires reach the msd unit and the coil. The pn 8920 will correct the operation of most voltage triggered tachometers that do not work directly off the tach output terminal of the msd control.

Fit new wire from the female female connector and run the wire directly from the spool through an open point on the firewall. If the tach still registers incorrectly install this tach adapter. Some vehicles with factory tachometers may require a tach. 7 for wiring and tach adapter information.

We drill a new hole and run the wires through the firewall below the starter solenoid. Voltage triggered and current triggered. Vehicles originally equipped with a cd ignition control cannot use an msd. Splice the white wire from the pn 8910 into the msd s white trigger wire.

A good quality helically wound wire and proper routing are required to get the best performance from your ignition such. Figure 1 wiring the tach adapter. There are two style tachometers that may have been used on your vehicle. There are two style tachometers that may have been used on your vehicle.

This terminal provides a trigger signal for tachometers a shift light or other add on rpm activated devices. If your tachometer doesn t work correctly after installing an msd ignition control always try to connect the tach s trigger wire directly to the tach output of the ignition. The tach output terminal produces a 12 volt square wave signal with a 20 duty cycle. If you are using the magnetic pickup input green and violet wires to trigger your msd ignition you will need the pn 8920 tach adapter.

Spark plugs and wires spark plug wires are very important to the operation of your ignition system. Strip the end of the trigger wire for the tachometer and place a female to female connector to it. If the tach still registers incorrectly install this tach adapter. The auto meter tach adapter wires in line on the positive 12 volt supply wire.

Msd tach adapter pn 8920. It senses current on the coil positive wire and converts it to a 12 volt signal output. The auto meter tach adapter wires in line on the positive 12 volt supply wire. If your tachometer doesn t work correctly after installing an msd ignition control always try to connect the tach s trigger wire directly to the tach output of the ignition.

It is recommended to have a wiring schematic of your vehicle s ignition system to clearly identify the coil positive 12 volt supply.